09-28-2007 01:32 AM - edited 03-03-2019 06:56 PM
i have a 2811 router with (C2800NM-ADVIPSERVICESK9-M), Version 12.4(15)T. I was intending to configure this E1 card for Data but it doesn't take me to the controller interface. what might be the problem? can this vwic do data?
09-28-2007 02:18 AM
Hi,
I think it does support data as well. What does the show diag show?
Krisztian
09-28-2007 02:33 AM
Hi,
Configure the command -- card type E1
Regards
Santhosh M.C
Cable&Wireless
09-28-2007 02:46 AM
Hi,
Try the following,
Router(config)# card type e1 subslot
Then,
Router(config)#controller E1 port
Go on to configure the controller as usual followed by your serial interface.
Cheers,
09-28-2007 04:05 AM
Actually, VWIC-xMFT-E1 does not need 'card type' command. Only the VWIC2 cards do need it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: