09-28-2007 01:32 AM - edited 03-03-2019 06:56 PM
i have a 2811 router with (C2800NM-ADVIPSERVICESK9-M), Version 12.4(15)T. I was intending to configure this E1 card for Data but it doesn't take me to the controller interface. what might be the problem? can this vwic do data?
09-28-2007 02:18 AM
Hi,
I think it does support data as well. What does the show diag show?
Krisztian
09-28-2007 02:33 AM
Hi,
Configure the command -- card type E1
Regards
Santhosh M.C
Cable&Wireless
09-28-2007 02:46 AM
Hi,
Try the following,
Router(config)# card type e1 subslot
Then,
Router(config)#controller E1 port
Go on to configure the controller as usual followed by your serial interface.
Cheers,
09-28-2007 04:05 AM
Actually, VWIC-xMFT-E1 does not need 'card type' command. Only the VWIC2 cards do need it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide