MIB value for Interface transceiver threshold

Unanswered Question
Sep 28th, 2007

Does anyone know the MIB value equivalent to "show interface transceiver threshold". There is a supported trap but despite many searches I have not found this yet. I want to monitor the optical power on the transceiver. I did previously ask on the network management forum but have not resolved this.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
htarra Thu, 10/04/2007 - 11:54

The "show interface transceiver CLI" takes nearly 2 minutes to execute. show interfaces transceiver :To display diagnostic-monitoring data for all interfaces that have transceivers installed, use the show interfaces transceiver command.

show interfaces {{[int_name] transceiver {[detail | calibration]} | {transceiver [module

mod] | detail [module mod] | calibration [module mod]}}

Actions

This Discussion