Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
880
Views
0
Helpful
1
Replies

MIB value for Interface transceiver threshold

james.robinson
Level 1
Level 1

‎09-28-2007 03:42 AM - edited ‎03-05-2019 06:45 PM

Does anyone know the MIB value equivalent to "show interface transceiver threshold". There is a supported trap but despite many searches I have not found this yet. I want to monitor the optical power on the transceiver. I did previously ask on the network management forum but have not resolved this.

Labels:
0 Helpful
1 Reply 1

htarra
Level 4
Level 4

‎10-04-2007 11:54 AM

The "show interface transceiver CLI" takes nearly 2 minutes to execute. show interfaces transceiver :To display diagnostic-monitoring data for all interfaces that have transceivers installed, use the show interfaces transceiver command.

show interfaces {{[int_name] transceiver {[detail | calibration]} | {transceiver [module

mod] | detail [module mod] | calibration [module mod]}}

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card