Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
585
Views
5
Helpful
5
Replies

Load Balance WAN

marcio.tormente
Level 4
Level 4

‎09-28-2007 05:19 AM - edited ‎03-05-2019 06:45 PM

People,

How to configure load balance with two link serial into same router?

This links go out for internet.

Thanks

Labels:
0 Helpful
5 Replies 5

Richard Burts
Hall of Fame
Hall of Fame

‎09-28-2007 05:43 AM

Marcio

The most simple and frequently best was to load share over 2 serial links is to configure 2 static default routes, one static default route pointing at each serial interface (or next hop address over the serial interface).

HTH

Rick

HTH

Rick
0 Helpful

marcio.tormente
Level 4
Level 4
In response to Richard Burts

‎09-28-2007 05:52 AM

Rick,

Thanks for your answer, but this not possible because that link go out for internet and need use NAT.

I tried this, but he did not function.

Do you have another sugestion?

Thanks

0 Helpful

Richard Burts
Hall of Fame
Hall of Fame
In response to marcio.tormente

‎09-28-2007 06:07 AM

Marcio

NAT does not need to intefere with using static default routes. What was the problem?

HTH

Rick

HTH

Rick
0 Helpful

marcio.tormente
Level 4
Level 4
In response to Richard Burts

‎09-28-2007 06:53 AM

Rick,

If i not use NAT, i can?t go out for internet.

I try again

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card