09-28-2007 05:19 AM - edited 03-05-2019 06:45 PM
People,
How to configure load balance with two link serial into same router?
This links go out for internet.
Thanks
09-28-2007 05:43 AM
Marcio
The most simple and frequently best was to load share over 2 serial links is to configure 2 static default routes, one static default route pointing at each serial interface (or next hop address over the serial interface).
HTH
Rick
09-28-2007 05:52 AM
Rick,
Thanks for your answer, but this not possible because that link go out for internet and need use NAT.
I tried this, but he did not function.
Do you have another sugestion?
Thanks
09-28-2007 06:07 AM
Marcio
NAT does not need to intefere with using static default routes. What was the problem?
HTH
Rick
09-28-2007 06:53 AM
Rick,
If i not use NAT, i can?t go out for internet.
I try again
09-28-2007 11:07 AM
People,
Follow the link with solution this problem.
http://www.ciscotaccc.com/kaidara-advisor/iprout/showcase?case=K81227071
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: