Authenticate using both RADIUS & TACACS+ at the same time within ACS

Unanswered Question
Sep 28th, 2007


How does one configure a network device in ACS 4.0 to authenticate using both TACACS+ and RADIUS? Bascially there's only one option from the drop down list that can be selected.

Basically I have a Cisco switch: I want to use TACACS+ for remote admin security and RADUIS for dot1.x / NAC

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Jagdeep Gambhir Sun, 09/30/2007 - 06:19


You can add same device again with the condition of keeping different host name,



Host name

1). Switch--->IP x.x.x.x ---> Auth using Radius

Add it again as

2). Switch1----->IP x.x.x.x---> Auth using TACACS+



Please rate helpful posts

darpotter Tue, 10/02/2007 - 02:00

To avoid confusion call your device name

deviceXYZ_R and deviceXYZ_T


This Discussion