cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
266
Views
5
Helpful
3
Replies

VIC not supported?

goranpilat
Level 3
Level 3

Hi all!

I installed CCM 5.1(2b) and wanted to add an MGCP gateway (I installed it on 2811) with WIC-1B-S/T-V3 to the configuration for the outgoing calls. The problem is that when I configure GW, in "Configured Slots, VICs and Endpoints -> Module in Slot 0 ->NM-4WVIC-MBRD" I dont get WIC-1B-S/T-V3 as an option, only VIC2-2BRI. Does it mean that CCM doesn't support this card or am I doing something wrong?!?

best regards,

Goran

3 Replies 3

Rob Huffman
Hall of Fame
Hall of Fame

Hi Goran,

This card is not supported for voice :(. Here is an excerpt from a good doc;

Q. Does the 4-port BRI expansion module support voice and data?

A. The 4-port BRI expansion module supports voice services only. A BRI service provides two 64-kbps B-channels for voice or data and one 16-kbps D-channel for signaling information or data.** BRI data support is available with the Cisco 1-Port BRI S/T WAN card (part number WIC-1B-S/T-V3.

http://www.cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml

Hope this helps!

Rob

Thanx very much, helps indeed :)

br,

goran

Hi Goran,

You are most welcome :) Sorry for being the bearer of bad news!

Take care,

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: