MLPPP routing issue

Unanswered Question
Oct 3rd, 2007

hi,


I have two t1's bonded together using MLPPP. I have all the interfaces, Serial0, Serial1, MLPPP all show up and up.


the issue is I can not send any traffic over the mlppp circuits, I try to ping across but no luck. Attached is my show run and show multilink. Any help would be great.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Wed, 10/03/2007 - 22:01

hi


can you check the config line under multilink interface ?


ip address 10.10.10.2 255.255.255.0


is its coz of some typo ? whats the ip address configured at the other end ?


do check this and correct it out that may solve your problem.


regds


royalblues Thu, 10/04/2007 - 02:35

Try clearing the multilink bundle

clear interface multilink


Can you post a sh ip route?


Narayan




a.strobel Thu, 10/04/2007 - 04:02

yes this ip is correct. The other side is 10.10.10.1


Not sure why but when we put in the shoretel voip system they said I had to bridge the two networks instead of just using routing.



Actions

This Discussion