10-03-2007 08:07 PM - edited 03-03-2019 07:01 PM
hi,
I have two t1's bonded together using MLPPP. I have all the interfaces, Serial0, Serial1, MLPPP all show up and up.
the issue is I can not send any traffic over the mlppp circuits, I try to ping across but no luck. Attached is my show run and show multilink. Any help would be great.
10-03-2007 10:01 PM
hi
can you check the config line under multilink interface ?
ip address 10.10.10.2 255.255.255.0
is its coz of some typo ? whats the ip address configured at the other end ?
do check this and correct it out that may solve your problem.
regds
10-04-2007 02:35 AM
Try clearing the multilink bundle
clear interface multilink
Can you post a sh ip route?
Narayan
10-04-2007 04:02 AM
yes this ip is correct. The other side is 10.10.10.1
Not sure why but when we put in the shoretel voip system they said I had to bridge the two networks instead of just using routing.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide