10-03-2007 08:47 PM - edited 03-05-2019 06:52 PM
I have a catalyst switch 3400 on which I have configured a port as trunk and added some vlans to it using 'switchport trunk allowed add vlan x,y ' command. Next I removed all vlans from this port and changed it to an access port.The issue is that when an access VLAN is configured on this port the "switchport trunk allowed vlan none" is still configured on the port.I would like the switch to return to defalut configuration after it is changed to access mode. Is there a way to do so ?
10-03-2007 08:54 PM
Hi Friend,
Did you tried adding "no" with the same command. Something like this "no switchport trunk allowed vlan
Also is it 3500XL switch? as there is no switch model as 3400?
Regards,
Ankur
10-03-2007 09:47 PM
Hello Ankur,
Thanks for the tip.I tried "no switchport trunk allowed vlan".
It has cleared the previous configuration.
The device I am using is Catalyst 3400ME.
10-03-2007 10:04 PM
Hi Friend,
Great to know it worked for you. I missed that switch from my knowledgebase. Anways thanks for the updates.
Regards,
Ankur
*Pls rate all helpfull post
10-03-2007 10:54 PM
Here is another tip: the quickest way to return an interface to its default settings is default int F0/1
Kevin Dorrell
Luxembourg
10-03-2007 11:40 PM
Thanks Kevin. I will try that as well.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: