Rajesh Revuru Thu, 10/04/2007 - 12:16
User Badges:
  • Silver, 250 points or more

Please check "Call Waiting timer" under the service parameters

rgoodwin7399 Thu, 10/04/2007 - 12:24
User Badges:

Thank you for the reply. I am trying to find that paramater and not able to. What page is it on?

Rajesh Revuru Thu, 10/04/2007 - 12:41
User Badges:
  • Silver, 250 points or more

Apologies.. that parameter is only available until 3.3. For new 4.x they have introduced busy trigger.


I am not sure how to change the beep timer on call-waiting.

rgoodwin7399 Thu, 10/04/2007 - 12:43
User Badges:

Ok. Well thank you for the replies anyway. From what I have seen it doesn't look like you can change the beep-timer in 4.x.

Rob Huffman Thu, 10/04/2007 - 13:15
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Rachel,


Have you tried this setting on the Directory Number Configuration Page>Line Settings for this Device>Ring Setting (Phone Active)


This can toggle between Ring Once and Ring (which continues to Ring)


Hope this helps!

Rob

rgoodwin7399 Thu, 10/04/2007 - 13:44
User Badges:

That gets me an audible ring which is nice but what I am really trying to do is make it beep more than once on a second incoming call. Is that possible with CCM 4.1.3? The obvious drawback to the "ring" setting is that it is loud for the user and whoever they might be on the phone with.

Actions

This Discussion