10-04-2007 12:47 PM - edited 03-11-2019 04:21 AM
Hi,
I have a 1721 cisco router with the ethernet port and a lan wic.
The router has 192.168.156.252 ip configured. We have configured with 192.168.156.25 ip address a router connected by my isp.This router has been configured with this ip, we can not change it or enter to administer the software.
I tried to connect a lan wire from this router(teldat) to the 1721 ethenet wic port and use the IOS firewall to filter certain ports.. protocols and more...
Using SDM 2.4.1 I tried to configure the firewall but the wizard says that they have the same lan ip and it is impossible.
what can I do?
best regards
10-05-2007 10:26 AM
Either subnet the two interfaces so they are logically different or change one of them to a new subnet.
10-05-2007 03:49 PM
Hi,
I do not understand you.
Can you explain better?
Best regards
10-07-2007 05:57 AM
I will try, put a different network on the interface so they do not overlap, you can either use subnetting or something like
10.0.0.1 255.255.255.0
I recommend you google subnetting and read up on it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide