10-04-2007 03:55 PM - edited 03-05-2019 06:54 PM
I have setup a lab with 2 routers with T1 WICs. I was wondering if I could configure the T1s with freme-relay, would that work? I have tried them with PPP and that worked fine.
Thanks in advance,
10-04-2007 04:10 PM
Yes you can. Here's the link.
http://www.cisco.com/en/US/tech/tk713/tk237/technologies_configuration_example09186a0080094a3b.shtml
HTH
Sundar
10-05-2007 05:50 AM
Sadik
Sundar is quite correct that you can configure 2 routers with back to back serial connection to use frame relay encapsulation. Be aware that without a device acting as a frame relay switch that it will not act entirely as real frame relay does. For example there will be no LMI in a back to back frame relay configuration. There is also no processing for DE frames or for FECN or BECN.
HTH
Rick
10-05-2007 08:06 AM
Thaks to both of you. That helped!
sK
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: