Cisco 500 Series - Port Security

Answered Question
Oct 4th, 2007

Hi,

Does anybody know how the port security works with Cisco 500 Series. I can not restrict one mac-address to one port manually so, how does it works?

I have this problem too.
0 votes
Correct Answer by Jagdeep Gambhir about 9 years 2 months ago

Depending on the Smartport Role you assign the CE500 design has a port security. For instance the port role Access Point will only allow a maximum of 30 MAC addresses only and the Ip Phone + Desktop will allow only 3 MAC addresses.

http://www.ciscotaccc.com/kaidara-advisor/lanswitching/showcase?case=K43299660

So by configuring smartport, you are also configuring port security.

Regards,

~JG

Please rate helpful posts

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
muca Thu, 10/04/2007 - 17:31

What I mean is that I can not specify the maximum number of devices right? And just one device is allowed on the port

Correct Answer
Jagdeep Gambhir Fri, 10/05/2007 - 05:38

Depending on the Smartport Role you assign the CE500 design has a port security. For instance the port role Access Point will only allow a maximum of 30 MAC addresses only and the Ip Phone + Desktop will allow only 3 MAC addresses.

http://www.ciscotaccc.com/kaidara-advisor/lanswitching/showcase?case=K43299660

So by configuring smartport, you are also configuring port security.

Regards,

~JG

Please rate helpful posts

muca Fri, 10/05/2007 - 13:55

Thank you very much. That's the exactly information I was looking for.

Actions

This Discussion