ACL help

Unanswered Question
Oct 5th, 2007
User Badges:

I have an extended ACL configured on a router denying traffic from a host through port 80. The problem is it is not being applied to the interface. How can I bound this ACL to an interface? Is there any documentation out there that goes over these steps?


thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Jon Marshall Fri, 10/05/2007 - 07:05
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


You apply an acl to an interface with the following


int fa0/1

ip access-group "acl_name" in|out


HTH


Jon

siscisco05 Fri, 10/05/2007 - 07:14
User Badges:

Ok, thanks for the help. Is there a way to verify that it is attached to the interface?

Richard Burts Fri, 10/05/2007 - 07:13
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Sean


If you have configured the access list then the way that you apply it (or bind it) to the interface is with the command ip access-group in|out


If you are looking for documentation you could start with this link:

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080430e5b.html#wp1066643


[edit] seeing your response - if you want to check that the ACL is bound to the interface I would suggest doing show ip interface . This output shows any inbound or outbound access lists that have been configured.


HTH


Rick

Actions

This Discussion