10-05-2007 07:02 AM - edited 03-05-2019 06:55 PM
I have an extended ACL configured on a router denying traffic from a host through port 80. The problem is it is not being applied to the interface. How can I bound this ACL to an interface? Is there any documentation out there that goes over these steps?
thanks
10-05-2007 07:05 AM
Hi
You apply an acl to an interface with the following
int fa0/1
ip access-group "acl_name" in|out
HTH
Jon
10-05-2007 07:14 AM
Ok, thanks for the help. Is there a way to verify that it is attached to the interface?
10-05-2007 07:13 AM
Sean
If you have configured the access list then the way that you apply it (or bind it) to the interface is with the command ip access-group
If you are looking for documentation you could start with this link:
[edit] seeing your response - if you want to check that the ACL is bound to the interface I would suggest doing show ip interface
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: