CCME, ATA and Faxing

Unanswered Question
Oct 5th, 2007
User Badges:

Hi,


I have Cisco Call Manager running on a 2800 series router and have a Cisco ATA-186 (SCCP firmware) that I wish to use for a couple of faxes. I've tried adding the following lines to my configuration however whilst a fax answers an incoming call it does not seem to be able to negotiate with the sending fax & obviously fails. I cannot send outgoing faxes at all. Config lines:-


ephone-dn 24 dual-line

number 2214

description fax1

call-forward busy 600

call-forward noan 600 timeout 15


ephone 24

mac address xxxx.xxxx.xxxx

type ata

button 1:24


The ATA is also configured Audio Mode 0x00150015


Any one any ideas?


Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
connect101 Fri, 10/05/2007 - 07:25
User Badges:

I think you must configure the fax relay or something like this.

Actions

This Discussion