AnyConnect with ASA 8.02 not routing packets.

Unanswered Question
Oct 5th, 2007
User Badges:

I have the Anyconnect client successfully working in the sense that I am able to login successfully, the AnyConnect client shows that I have an IP address from the range that I have setup, but I am unable to ping, telnet, surf the web etc.


Do I need to setup an additional static statement for the range of IP addresses I'm using? or use a nat 0 statement? I"m using a publicly routable block of IP addresses and if I do a 'show route' on the PIX I am able to see the IP address show up in the route table.


Any help or suggestions would be appreciated. Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dbobeldyk Fri, 10/05/2007 - 07:38
User Badges:

BigPix# show vpn-sessiondb svc


Session Type: SVC


Username : denny Index : 7

Assigned IP : x.x.27.195 Public IP : y.y.y.y

Protocol : Clientless SSL-Tunnel DTLS-Tunnel

Encryption : RC4 AES128 Hashing : SHA1

Bytes Tx : 782727 Bytes Rx : 551731

Group Policy : DfltGrpPolicy Tunnel Group : DefaultWEBVPNGroup

Login Time : 11:38:50 EDT Fri Oct 5 2007

Duration : 0h:00m:10s

NAC Result : Unknown

VLAN Mapping : N/A VLAN : none



Actions

This Discussion