10-06-2007 04:48 PM - edited 03-15-2019 06:50 AM
We have a CME at one location (Location A) that has a PRI to the PSTN. At another location (Location B) we have a Cisco voice gateway that has a PRI connection to a PBX.
I can successfully call from the CME to the PBX however when a user on the PBX calls an extension on the CME they get a dialtone, then if they dial the extension again the call goes thru. What an I doing wrong????
Topology:PSTN<--PRI-->CME (site A)<--WAN-->Cisco gateway(Site B)<--PRI-->PBX
Location A Extension Range: 10xx
Location B Extension Range: 88xx
-------Location A Dial Peers------
dial-peer voice 1 pots
description ** PRI to PSTN
translation-profile outgoing CallerID
destination-pattern 9T
port 0/0/0:23
forward-digits all
!
dial-peer voice 100 voip
description ** 4 Digit Calls to Location B
destination-pattern 88..
session protocol sipv2
session target ipv4:10.10.100.1
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 101 voip
description --> Incoming VoIP Calls From Location B
session protocol sipv2
session target ipv4:10.10.100.1
incoming called-number .
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
-------Location B dial peers-------
dial-peer voice 1 pots
description ** 4 Digit Calls to Location B PBX
destination-pattern 88..
incoming called-number .
port 0/3/0:15
forward-digits 4
!
dial-peer voice 100 voip
description ** 4 Digit Calls to Location A
destination-pattern 10..
session protocol sipv2
session target ipv4:10.10.100.1
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 101 voip
description ** Incoming VoIP Calls From Location A
session protocol sipv2
session target ipv4:10.10.200.1
incoming called-number .
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
Solved! Go to Solution.
10-06-2007 06:29 PM
Hi,
configure "direct-inward-dial" and add "incoming called-number xx.." to your DP 100.
Hope this helps, please rate post if it does!
10-06-2007 06:29 PM
Hi,
configure "direct-inward-dial" and add "incoming called-number xx.." to your DP 100.
Hope this helps, please rate post if it does!
10-08-2007 11:25 PM
Thanks. That was the issue. I needed direct inward dial on the pots dial peer.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: