Jon Marshall Sun, 10/07/2007 - 23:21
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


i don't believe this is your IOS, it is the ROMMON code.


Can you do a "dir flash:" from the enable prompt. That should show you IOS or


output from one of our 2800 routers


=============================================


R6#sh ver

Cisco IOS Software, 2801 Software (C2801-IPBASE-M), Version 12.4(1c), RELEASE SOFTWARE (fc1) <---- this is your IOS

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2005 by Cisco Systems, Inc.

Compiled Wed 26-Oct-05 08:42 by evmiller


ROM: System Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fc1)


R6 uptime is 4 days, 16 hours, 39 minutes

System returned to ROM by reload at 14:43:01 UTC Wed Oct 3 2007

System image file is "flash:c2801-ipbase-mz.124-1c.bin"


Cisco 2801 (revision 5.0) with 114688K/16384K bytes of memory.

Processor board ID FCZ10082521

2 FastEthernet interfaces

1 Serial(sync/async) interface

DRAM configuration is 64 bits wide with parity disabled.

191K bytes of NVRAM.

62720K bytes of ATA CompactFlash (Read/Write)


Configuration register is 0x2102


=============================================


HTH


Jon


Actions

This Discussion