10-08-2007 01:45 AM - edited 03-15-2019 06:51 AM
hi folks,
i am not able to log into UC500 box.
the manual says i should get the DHCP when connected to box .but i am not getting
can somebody tell me what is the default password for UC500 box.
or how to set it to default value.
or password recovery.
thx for ur consideration.
10-08-2007 01:50 AM
Connect via serial cable to console port. As the banner indicates, the default is cisco/cisco.
Hope this helps, please rate post if it does!
10-08-2007 01:56 AM
thx but its not working.
cisco/cisco is not working somebody might have changed it. i am working in my lab on this box.
any password recovery.
10-08-2007 02:09 AM
Apply the standard router password recovery:
http://cisco.com/en/US/products/hw/routers/ps259/products_password_recovery09186a0080094675.shtml
hope this helps, please rate post if it does!
10-08-2007 03:06 AM
As I recall, I think the default username / password for my UC520 was:
username: Cisco
password: Cisco
(Note the C is upper case)
04-05-2019 01:56 PM
How do I find the IP address for CCA
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: