Cisco7609 ? cannot configure the ports as ?switchport?

Unanswered Question
Oct 8th, 2007
User Badges:

Hi,


After replacing a WS-X6548-GE-TX, I cannot configure the ports as ?switchport?:


swit(config)#interface gigabitEthernet 2/48

swit(config-if)#switchport

swit(config-if)#switchport mode access

Command rejected: Gi2/48 not a switching port.


If I change the slot it works, the problem just happens with slot 2. Before, it was working:


swit#sh startup-config | b 2/48

interface GigabitEthernet2/48

no ip address

speed 1000

switchport

switchport access vlan 500

switchport mode access

spanning-tree portfast


The supervisor is a WS-X6K-S2U-MSFC2.


Thanks a lot,


Marcelo


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
glen.grant Mon, 10/08/2007 - 17:09
User Badges:
  • Purple, 4500 points or more

Try defaulting the interfACE and reinputting the info . Also "switchport" has to be the very first command.


conf t

default interface G2/48

m.carvalho Mon, 10/08/2007 - 20:15
User Badges:

Hi,


I tried clearing the entire configuration module and did not work. I replaced the line card for a new one and did not work too.

Only with the version upgrade it worked.

Thanks a lot for your attention.


Regards,


Marcelo


m.carvalho Mon, 10/08/2007 - 20:11
User Badges:

Hi,


The problem was due a BUG in the version. With the upgrade it is working.


Old version: c6sup22-psv-mz.121-19.E1a

New version: c6sup22-psv-mz.121-27b.E3.bin


Thanks,


Marcelo

Actions

This Discussion