10-08-2007 01:06 PM - edited 03-05-2019 06:57 PM
Hi,
After replacing a WS-X6548-GE-TX, I cannot configure the ports as ?switchport?:
swit(config)#interface gigabitEthernet 2/48
swit(config-if)#switchport
swit(config-if)#switchport mode access
Command rejected: Gi2/48 not a switching port.
If I change the slot it works, the problem just happens with slot 2. Before, it was working:
swit#sh startup-config | b 2/48
interface GigabitEthernet2/48
no ip address
speed 1000
switchport
switchport access vlan 500
switchport mode access
spanning-tree portfast
The supervisor is a WS-X6K-S2U-MSFC2.
Thanks a lot,
Marcelo
10-08-2007 05:09 PM
Try defaulting the interfACE and reinputting the info . Also "switchport" has to be the very first command.
conf t
default interface G2/48
10-08-2007 08:15 PM
Hi,
I tried clearing the entire configuration module and did not work. I replaced the line card for a new one and did not work too.
Only with the version upgrade it worked.
Thanks a lot for your attention.
Regards,
Marcelo
10-08-2007 08:11 PM
Hi,
The problem was due a BUG in the version. With the upgrade it is working.
Old version: c6sup22-psv-mz.121-19.E1a
New version: c6sup22-psv-mz.121-27b.E3.bin
Thanks,
Marcelo
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide