Dear all,
i have a cisco 1841 router and i installed 2 bri module in it and configured that router my NT box is unable to dail automatically . when i keep phone instrumnets to NT box and dail a number its port is coming to active and when i test a call then the 2 b-channels is coming up and same with the other port also....
please help me any one who implemented this...i am giving my configuration.
THIS IS MY 1841 END ROUTER CONFIGURATION
CISCO#sh run
Building configuration...
hostname CISCO
ip domain name yourdomain.com
ip multicast-routing
isdn switch-type basic-5ess
interface FastEthernet0/0
ip address 192.168.8.49 255.255.255.0
ip accounting output-packets
ip pim dense-mode
ip igmp join-group 239.0.0.1
speed auto
full-duplex
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface BRI0/0/0
no ip address
ip directed-broadcast
encapsulation ppp
dialer rotary-group 1
dialer-group 1
isdn switch-type basic-5ess
isdn point-to-point-setup
!
interface BRI0/1/0
no ip address
ip directed-broadcast
encapsulation ppp
dialer rotary-group 1
dialer-group 1
isdn switch-type basic-5ess
isdn point-to-point-setup
!
interface Dialer1
ip unnumbered FastEthernet0/0
ip access-group dialer_in in
ip access-group dialer_out out
ip pim dense-mode
encapsulation ppp
ip igmp join-group 239.0.0.1
dialer in-band
dialer string 66682540
dialer load-threshold 1 either
dialer-group 1
ppp multilink
!
ip classless
ip route 0.0.0.0 0.0.0.0 Dialer1
!
no ip http server
ip http authentication local
ip http timeout-policy idle 60 life 86400 requests 10000
!
ip access-list extended dialer_in
permit tcp any any syn log-input
permit ip any any
ip access-list extended dialer_out
permit tcp any any eq www
permit tcp any any eq 443
permit udp any any
permit icmp any any
permit tcp any host 192.168.25.2
permit tcp any host 192.168.25.3
permit tcp any host 192.168.25.110
permit tcp any host 192.168.25.101
permit tcp any host 192.168.25.21
deny tcp any any eq 445
permit tcp any any syn log-input
permit ip any any
!
dialer-list 1 protocol ip permit
!
control-plane
!
!
line con 0
login local
line aux 0
line vty 0 4
privilege level 15
password CISCO123
login
transport input telnet
line vty 5 15
privilege level 15
login local
transport input telnet
!
THIS IS MY PRI ROUTER CONFIGURATION
interface Dialer131
ip unnumbered FastEthernet0/0
ip access-group in_traffic in
ip access-group out_traffic out
ip pim dense-mode
encapsulation ppp
ip route-cache flow
ip igmp join-group 239.0.0.1
dialer pool 1
dialer idle-timeout 3600 either
dialer caller 4066470717
dialer caller 4066451127
peer default ip address dhcp-pool local-branches
ppp multilink
PLEASE GIVE ME SOLUTION WHERE I DID WRONG IN THIS CONFIGURATION...
IN ADVANCE THANKS
