RARP proxy

Unanswered Question
Oct 9th, 2007

Hi,

Can anybody tell me how to configure the RARP proxy on a cisco switch.

Regards,

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
thomas.anthony Tue, 10/09/2007 - 05:33

To enable proxy ARP on an interface, use the ip proxy-arp interface configuration command.

The following example enables proxy ARP on Ethernet interface 2/0/0.

Switch(config)# interface ethernet 2/0/0

Switch(config-if)# ip proxy-arp

Use the ip rarp-server interface configuration command to allow the switch to act as a Reverse Address Resolution Protocol (RARP) server. Use the no form of this command to restore the interface to the default of no RARP server support.

ip rarp-server ip-address

no ip rarp-server ip-address

Actions

This Discussion