cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
761
Views
0
Helpful
2
Replies

RARP proxy

hai_manish
Level 1
Level 1

Hi,

Can anybody tell me how to configure the RARP proxy on a cisco switch.

Regards,

2 Replies 2

thomas.anthony
Level 1
Level 1

To enable proxy ARP on an interface, use the ip proxy-arp interface configuration command.

The following example enables proxy ARP on Ethernet interface 2/0/0.

Switch(config)# interface ethernet 2/0/0

Switch(config-if)# ip proxy-arp

Use the ip rarp-server interface configuration command to allow the switch to act as a Reverse Address Resolution Protocol (RARP) server. Use the no form of this command to restore the interface to the default of no RARP server support.

ip rarp-server ip-address

no ip rarp-server ip-address

Hi,

My question was to configure proxy RARP.

Regards,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco