Jagdeep Gambhir Tue, 10/09/2007 - 06:55
User Badges:
  • Red, 2250 points or more

Hi Ed,

The command "switchport port-security limit rate invalid-source-mac" limits invalid source MAC address on a security port based on the pps (packets per second) value you configure

The default value is 10 pps. For example the below would limit packets from invalid source

MAC address to 100 pps

swithport port-security limit rate invalid-source-mac 100

If you would like to verify, you may try setting the pps to '0' in which case the switch would deny all invalid source MAC address packet.




This Discussion