10-09-2007 07:01 AM - edited 03-15-2019 06:53 AM
Hello,
I've installed a UC520. Now we've a problem with the directory lookup. When a external number exist in the directory, the name is not presented in the display when a call arrives from that external number. When I make the same configuration on a CME the name will be presented.
What can be the problem? Is this an UC500 issue?
Greets Niels
10-09-2007 07:14 AM
Do you have
service dnis dir-lookup
under telephony-service ?
hope this helps, please rate post if it does!
10-09-2007 10:05 PM
Yes, I always configure that setting.
This is the telephony-service configuration, I only changed the phone number :)
max-ephones 8
max-dn 10
ip source-address 192.168.12.210 port 2000
auto assign 1 to 10
service dnis overlay
service dnis dir-lookup
service dss
user-locale NL
user-locale 1 NL
user-locale 2 NL
user-locale 3 NL
user-locale 4 NL
network-locale NL
network-locale 1 NL
network-locale 2 NL
network-locale 3 NL
network-locale 4 NL
max-conferences 4 gain -6
transfer-system full-consult
directory entry 1 00553333333 name test
10-10-2007 12:06 AM
Hi Niels,
I know it might sound silly but does the incoming CLi on the number match the number in your directory? it could be that the number is not matching correctly, run a debug and see what the incoming number is
I hope this helps
Dave
10-10-2007 01:20 AM
Hi Dave,
Yes, I'm realy sure. The incoming number matches the directory entry. When I made the same configuration on a CME everything works fine. I've this problem only on the UC500.
10-10-2007 01:28 AM
Then I'm afraid you will need to log a case with the TAC. Consider that UC520 has newer IOS so the possibility of bugs is always there.
10-10-2007 11:17 PM
RTFM :)
10-11-2007 04:57 AM
tnx! thanks that will help...... :)
10-11-2007 05:54 AM
Hi, ive just tried doing this on my UC520.. and I get the same issue. Id be interested to know if the case is looked at by Cisco...
Hang on though.. It only seems to work when I do a group pickup. It displays the correct name from the directory, but it doesnt display on the phone the call was intended for.
10-11-2007 09:00 AM
Which exact IOS are you running on the UC520? Can you upgrade to 12.4(11)XW4 and try again ?
10-11-2007 09:11 AM
to be honest im not sure, i'll take a look tomorrow when I get to the office
10-14-2007 10:17 PM
Hi there, I've runned IOS 12.4(11)XW3 and upgraded later to XW4 it didn't help.
10-15-2007 01:57 AM
Now you can tell that it appears to be a bug in the latest version and you should log the problem with the TAC.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: