10-09-2007 12:00 PM - edited 03-03-2019 07:05 PM
While creating the master end of a cross connect between a RPM_PR & AXSM I am getting the following error:
addcon 8 0 50 5 1 -slave 4700918100000000016444472000000107730100.0.50 -lpcr 4000 -rpcr 4000 -lscr 4
000 -rscr 4000
ERR: Error in traffic parameters (dcmp)
The RPM sub interface configuration is:
interface Switch1.1 point-to-point
description Cross connect to AXSM
ip address 192.168.1.1 255.255.255.252
no ip route-cache
pvc 0/50
oam-pvc manage
encapsulation aal5snap
!
switch connection vcc 0 50 master remote
pcr 4000
scr 4000
rpcr 4000
rscr 4000
I am not sure why I am getting this error, can anyone help with this?
10-15-2007 01:46 PM
It appears that the PNNI and AXSM DBs are out of synch. Could you please do ----- "dspcon 12:2.1:9 15 148" , on the PXM
and check if this connection exists ?
10-15-2007 03:00 PM
I am not sure which connection you are referring to, but the problem I was having was a result of a missing statement.
interface Switch1.1 point-to-point
description Cross connect to AXSM
ip address 192.168.1.1 255.255.255.252
no ip route-cache
pvc 0/50
vbr-nrt 1696 1696 100 <-- was missing
oam-pvc manage
encapsulation aal5mux ip
!
switch connection vcc 0 50 master local raddr xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
pcr 4000
scr 4000
rpcr 4000
rscr 4000
rmbs 100
The question I have now is: what PVC encapsulation type should I use on this subinterface to terminate a PVC coming from FRSM configured for frame forwarding?
I am currently using aal5mux ip but the PVC is showing failed.
10-16-2007 12:57 AM
Hi Smith
Please try this one
addcon if vpi vci NSAP -lpcr -rpcr -lscr -rscr -lmbs -rmbs
regards
pawan
10-25-2007 03:33 AM
A couple of things...
On the AXSM you set the Service Type = 5 nrt-VBR.1, however on the RPM you have not set the corresponding parameter. Example IOS command in PVC config mode is:
vbr-nrt
If you do not set the QoS param on the RPM, it will default to UBR with 100% PCR bandwidth, hence "error in traffic parameters" which refers to both the QoS value and the Cell Rates.
If you select vbr-nrt on the RPM the corresponding AXSM QoS is nrt-vbr.3 - option 7.
Be sure to match the cell rates exactly. Cell rates entered in PVC config mode are Kbps for output-PCR and output-SCR and cells for output-MBS.
Values entered in switch conn config mode are cells!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: