I have cat 4006 switch in working as core switch with WS4232 routing module. it has a HW failuer and cousing a lot of proplems so I am going to replace it with Cat 4506 Core.
currently my config as the following
- 4 Network segments (4 Vlans), each one is trunked to Gb interface on the routing blade for intervlan routing.
- static route is there as last resort route
- some ACLs are applied between interfaces.
I want to know what is the best configuration to apply it in the new L3 core 4500. and how to create Vlans and handle the intervlan routing since there is no trunking and router interfaces cuz this is my first time to work on L3 switch.
You can use range command to do it in one shot so try something like this
cat4500_switch(config)#interface range gig2/3 - 30
cat4500_switch(config-if-range)#switchport access vlan 2
*Pls rate all helpfull post