ACS Radius AV pair

Unanswered Question


I was hoping someone could point me in the right direction, I am having a problem configuring AnyConnect with ASA 8.02 with Mutable groups as it seems the only way to do this is during authentication, the RADIUS server can push down the webvpn:user-vpn-group attribute. I am unable to see how to configure the ACS to use AV pairs I have enabled the Radius within the ACS but unsure on where to put the value webvpn:user-vpn-group.

Many thanks MJ

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Jagdeep Gambhir Wed, 10/10/2007 - 16:44


You need to use radius attribute 25. It is configured in user/group setup (either place depending if you want to lock a single user, or a whole group into a tunnel group)




This Discussion