AIR-ANT2506

Unanswered Question
Oct 11th, 2007
User Badges:

Hi,

I have installed an access-point 1242 and for arise signal I have installed also antenna AIR-ANT2506 instead of AIR-ANT4941.

Have to I modify some parameter on configuration ?

best regards

Lorezo

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Thu, 10/11/2007 - 05:14
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Lorenzo,


You probably want to set the Left or Right Primary (I'm not on site right now so I can't see or remember) and take the setting out of Diversity;


Use the antenna configuration interface command to configure the radio receive or transmit antenna settings. Use the no form of this command to reset the receive antenna to defaults.


[no] antenna {receive | transmit} {diversity | left | right}

Syntax Description


receive

Specifies the antenna that the access uses to receive radio signals


transmit

Specifies the antenna that the access uses to transmit radio signals


diversity

Specifies the antenna with the best signal


left

Specifies the left antenna


right

Specifies the right antenna




Defaults


The default antenna configuration is diversity


Examples


This example shows how to specify the right receive antenna option:


AP(config-if)# antenna receive right



This example shows how to set the receive antenna option to defaults:


AP(config-if)# no antenna receive


From this doc;


http://www.cisco.com/en/US/products/hw/wireless/ps430/products_command_reference_chapter09186a0080147d8b.html#2448409


Hope this helps!

Rob


Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode