error with configuration assistant with UC500

Unanswered Question
Oct 11th, 2007

hi i am getting this error while i configure wireless in cisco configuration assistant.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Paolo Bevilacqua Thu, 10/11/2007 - 13:29


for professional configuration results, please use CLI only. What is that you want to do with wireless and what is that doesn't work ?

sandeep pokhriyal Fri, 10/12/2007 - 08:39


i want to configure wireless its in initial stage though i configured ssid and ip adress also but i am not able to detect it..

i checked docs on cisco also but they have very less on UC500.

also i have to configure three different network on UC500 but i am not able to get it.

can you help me out with some config

txx again..

Paolo Bevilacqua Fri, 10/12/2007 - 09:41

This is a working basic wireless config example:

interface Dot11Radio0

no ip address


ssid ucs520


station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding


interface Vlan1

no ip address

bridge-group 1

bridge-group 1 spanning-disabled


interface BVI1

ip address

Paolo Bevilacqua Sat, 10/13/2007 - 11:30

The radio interface doesn't support routing. So what you do, is to use BVI to configure a subnet that includes both wired and wireless devices.


This Discussion