10-11-2007 10:54 AM - edited 03-14-2019 11:54 PM
hi i am getting this error while i configure wireless in cisco configuration assistant.
10-11-2007 01:29 PM
Hi,
for professional configuration results, please use CLI only. What is that you want to do with wireless and what is that doesn't work ?
10-12-2007 08:39 AM
thxx..
i want to configure wireless its in initial stage though i configured ssid and ip adress also but i am not able to detect it..
i checked docs on cisco also but they have very less on UC500.
also i have to configure three different network on UC500 but i am not able to get it.
can you help me out with some config
txx again..
10-12-2007 09:41 AM
This is a working basic wireless config example:
interface Dot11Radio0
no ip address
!
ssid ucs520
!
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Vlan1
no ip address
bridge-group 1
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 10.0.97.1 255.255.255.0
10-13-2007 09:54 AM
thxx. but what is the need of BVI.
10-13-2007 11:30 AM
The radio interface doesn't support routing. So what you do, is to use BVI to configure a subnet that includes both wired and wireless devices.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide