10-11-2007 10:54 AM - edited 03-14-2019 11:54 PM
hi i am getting this error while i configure wireless in cisco configuration assistant.
10-11-2007 01:29 PM
Hi,
for professional configuration results, please use CLI only. What is that you want to do with wireless and what is that doesn't work ?
10-12-2007 08:39 AM
thxx..
i want to configure wireless its in initial stage though i configured ssid and ip adress also but i am not able to detect it..
i checked docs on cisco also but they have very less on UC500.
also i have to configure three different network on UC500 but i am not able to get it.
can you help me out with some config
txx again..
10-12-2007 09:41 AM
This is a working basic wireless config example:
interface Dot11Radio0
no ip address
!
ssid ucs520
!
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Vlan1
no ip address
bridge-group 1
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 10.0.97.1 255.255.255.0
10-13-2007 09:54 AM
thxx. but what is the need of BVI.
10-13-2007 11:30 AM
The radio interface doesn't support routing. So what you do, is to use BVI to configure a subnet that includes both wired and wireless devices.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: