Adsl config

Unanswered Question

I have a Cisco 1721 router with two wic Ethernet card and one fastethernet.

I have two internet isp one lease line and another adsl line. The adsl modem is non cisco product.

Please Help me

I need both to be connected in my router so, if any of them is down then internet could not stoped. pl help me to configure the following network.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Fri, 10/12/2007 - 07:11

To begin with, configure two "ip nat inside source list xx interface etethernet X overload" statements for the two int, and two default routes.

Verify that you can work the internet and both circuits are used at the same time.

After that a more advanced configuration can be done based on specific requirements.

The best would be if you can get a WIC-1ADSL card to connect directly to ADSL and eliminate the existing modem.


This Discussion