Configure 2 mc3810's to double the available analog ports.

Unanswered Question
Oct 14th, 2007

I presently have an mc3810 with 6 e&m ports connected via t1 voatm over a microwave link to a distant mc3810 with 6 e&m ports. Is it possible to add a mc3810 at each end connected by their ethernet ports with a x-over cable to double the number of e&m ports available without using another t1? Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Dennis Fogler Mon, 10/15/2007 - 02:30

This will work as long as its an MC3810 "V3" the "V3" unit supported H.323 dial-peers, which you will use to route calls on the second 3810, you add, to the 3810 with the t1 voatm connection. Basically voip between the two units with a cross over cable.

Actions

This Discussion