cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
232
Views
0
Helpful
1
Replies

Configure 2 mc3810's to double the available analog ports.

smithduluth
Level 1
Level 1

I presently have an mc3810 with 6 e&m ports connected via t1 voatm over a microwave link to a distant mc3810 with 6 e&m ports. Is it possible to add a mc3810 at each end connected by their ethernet ports with a x-over cable to double the number of e&m ports available without using another t1? Thanks

1 Reply 1

Dennis Fogler
Cisco Employee
Cisco Employee

This will work as long as its an MC3810 "V3" the "V3" unit supported H.323 dial-peers, which you will use to route calls on the second 3810, you add, to the 3810 with the t1 voatm connection. Basically voip between the two units with a cross over cable.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: