10-15-2007 01:38 AM - edited 03-03-2019 07:10 PM
hi team,
we have a ospf ring for our cdma network,which happens to be switched network.we have formed the ring using 4 hsw switch card in cisco1841 router.Now we r experiencing ping delay to one of our site in the ring.as per the ospf config,if one of the site is down ,it takes the alternate path,that's fine.how to enable rstp in the router switch port.
expecting ur reply
10-15-2007 02:23 AM
I dont think that the ether switch modules support RSTP. The faqs do not state it as a limitation but neither do they say it is supported
http://www.cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c026.shtml
You can however configure the port a SPT portfast port
HTH
Narayan
10-15-2007 03:43 AM
The basic verification of layer 2 loop is to verify MAC address forwarding table. Check on what port each devices MAC are being learned.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: