×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

1812 router... switch ports

Answered Question
Oct 15th, 2007
User Badges:

Hi all,

A question with regards to the 1812, I was hoping to be able to set specific mac-addresses to be able to access ports as we had done with previous switches eg:


switchport mode access

switchport port-security

switchport port-security mac-address xxxx.xxxx.xxxx


However I find no such commands in the ios, I've tried 12.4(6)T8 advK9 and also adventerprise, I've also gone through SDM and nothing along those lines either. Can anyone confirm that allowing only a specific MAC to access a specific port is do able on the 1812 ? Or is it aimed at the NAT/DHCP/Firewall side of things.

Thanks,

Steve.


Correct Answer by Jagdeep Gambhir about 9 years 10 months ago

Steve,

Only static port security is supported on the c18xx platforms.


The CLI is "mac-address-table secure"


Reference:


http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/swtc

h_r/swi_m1.htm#wp1085966


Regards,

~JG


Please rate helpful posts

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
svryder Tue, 10/16/2007 - 17:02
User Badges:

Hi JG,

Thanks for the reply, it took me a couple of goes to figure out that it doesn't drop the port once a secure mac is set in the table, it just doesn't talk if a different machine is connected! It has solved my problem so thanks again !

Actions

This Discussion