Hi all,

A question with regards to the 1812, I was hoping to be able to set specific mac-addresses to be able to access ports as we had done with previous switches eg:

switchport mode access

switchport port-security

switchport port-security mac-address xxxx.xxxx.xxxx

However I find no such commands in the ios, I've tried 12.4(6)T8 advK9 and also adventerprise, I've also gone through SDM and nothing along those lines either. Can anyone confirm that allowing only a specific MAC to access a specific port is do able on the 1812 ? Or is it aimed at the NAT/DHCP/Firewall side of things.

Thanks,

Steve.