cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
425
Views
0
Helpful
3
Replies

Delay after dialing 0 (for operator)

jhall2203
Level 1
Level 1

We have DN 0 assigned to a CCM 4.1 CTI Route Point for our greeting/operator (this appears configured correctly). The issue we are having is when internal users dial 0 to get to the operator. When a user dials 0, there is significant delay (10 seconds or so) before the call connects (we use 4-digit extensions internally). What needs to be done to allow a quicker, if not immediate, call connect when internal users dial 0?

3 Replies 3

shane.orr
Level 4
Level 4

This sounds like the classic case of digit matching overlap so there is another match somewhere in CM that begins with 0 and it waits until the inter-digit timeout expires before completing the call. Can you go to Route Plan Report and find patterns that begin with 0 and see if you have matching patterns.

That was the problem. Thank you for the heads-up.

AJAZ NAWAZ
Level 5
Level 5

One option you have is the modify the T302 timer. This is the time CCM will wait for the next digit before routing the call.

Choose service > service parameters > Callmanger

Scroll down to Clusterwide Parameters (Device - General), then look down the list for T302 Timer (msec)*

ICRC the default is 10000. That's why you are seeing a 10sec wait. The recommended is five or six seconds. Finding the balance is crucial. Test out how 5000msec feels for you.

hth,

Ajaz

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: