Pix(6.3(3)) to PIX (7.0 or 7.2(2) conversion

Unanswered Question
Oct 16th, 2007

Dear all,

I have Pix 520(6.3(3)) and i'd like to replace it with another one PIX525 (7.0 or 7.2(2)) But the problem is in the old config ( Conduit ,Fixup,interfaces , VPN and...)

how can i convert (move) the old config (6.3(3)) to the new one (7.2(2) or 7.0) and what about the activation key or the licence?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mherald Wed, 10/17/2007 - 23:05

I have done a few of these upgrades, with little to no problem. Any particular reason you ruled out 8.0(2) code? Anyway, I recently upgraded a 6.3(4) straight to 8.0(2) and had one problem, the remote user VPNs did not make it over cleanly. The Site to site VPNs did (and all other configuration). The only specific information in your list was I did not have conduits (nor any of my other upgrades). Fixup pretty much gets replaced with inspect maps.

Hope this helps,

Mike

Actions

This Discussion