3640 router upgrade.

Unanswered Question
Oct 16th, 2007
User Badges:

Folks,


I was tring to upgrade the IOS of one of my 3640 routers and in the process I was notified of lack of enough memory.I had to accept to erase the flash before the upgrade but before that could finish, I had one of my colleagues stepping on the power cable thereby putting the router off. Now when I connect to the router,it takes me to the rommon> mode i guess because it cannot find the IOS to load.


Could someone please show me how I can get the IOS loaded so I can boot into the router.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Tue, 10/16/2007 - 10:35
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


If you are really sure you have erased your current image you can use xmodem to copy an IOS onto the router but it's not quick, ie. probably want to set it off before you go home.


Attached is a link to using xmodem for a 3600 router.


http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml#proc_3600


HTH


Jon



Joseph W. Doherty Tue, 10/16/2007 - 16:58
User Badges:
  • Super Bronze, 10000 points or more

If you have an external flash card that you could place in another router, you could preload the IOS on it.

Actions

This Discussion