AP Group steps by CLI

Answered Question
Oct 17th, 2007
User Badges:

Hi,

I know how to do this by WCS or Web to WLC but not by CLI.

Config Guide doesn't seem to have it.


How do I use CLI to associate the

- AP Group (which I already created)

- the SSID

- the interface


Thanks, MH

Correct Answer by Rob Huffman about 9 years 9 months ago

Hi Mark,


Here are the CLI steps;


Note: Issue this command in order to enable the AP Group VLANs feature from the CLI:


config location enable/disable


Note: Issue this command in order to define the location string (AP group name) using the CLI:


config location add


Note: Issue this command in order to map the interface to the AP groups through the CLI:


config location interface-mapping add


Starting from Wireless LAN Controller Version 4.1.181.0, the commands to configure AP groups with the CLI have changed. In Version 4.1.181.0, these are the commands used to configure a new AP group with the CLI:


In order to enable an AP group, use this:


config wlan apgroup add


In order to delete an existing group, use this:


config wlan apgroup delete


In order to add a description to the AP group, use this:


config wlan apgroup description


In order to create a new AP group/WLAN/interface mapping, use this:


config wlan apgroup interface-mapping add


Note: Issue this command from the controller CLI in order to assign an AP group to an LAP:


config ap group-name


For WLCs that run version 4.1.181.0 or later, use this command to verify the AP Group VLAN configuration.


show wlan apgroups



From this good doc;


http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml


Hope this helps!

Rob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Rob Huffman Wed, 10/17/2007 - 04:55
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Mark,


Here are the CLI steps;


Note: Issue this command in order to enable the AP Group VLANs feature from the CLI:


config location enable/disable


Note: Issue this command in order to define the location string (AP group name) using the CLI:


config location add


Note: Issue this command in order to map the interface to the AP groups through the CLI:


config location interface-mapping add


Starting from Wireless LAN Controller Version 4.1.181.0, the commands to configure AP groups with the CLI have changed. In Version 4.1.181.0, these are the commands used to configure a new AP group with the CLI:


In order to enable an AP group, use this:


config wlan apgroup add


In order to delete an existing group, use this:


config wlan apgroup delete


In order to add a description to the AP group, use this:


config wlan apgroup description


In order to create a new AP group/WLAN/interface mapping, use this:


config wlan apgroup interface-mapping add


Note: Issue this command from the controller CLI in order to assign an AP group to an LAP:


config ap group-name


For WLCs that run version 4.1.181.0 or later, use this command to verify the AP Group VLAN configuration.


show wlan apgroups



From this good doc;


http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml


Hope this helps!

Rob

Actions

This Discussion

 

 

Trending Topics - Security & Network