10-17-2007 04:52 AM - edited 03-15-2019 12:00 AM
Hi,
Does anyone have the settings required for an FXO port using a BT phone line?
My FXO port is remaining offhook when calls have been disconnected...
Hope someone can help!
Thanks,
Peter.
10-17-2007 04:58 AM
Look at this document:
http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
You can try the "dualtone midcall" approach with cptone uk, but ofen doesn't work and you still have to configure the frequencies explicitly.
Hope this helps, please rate post if it does!
10-17-2007 05:05 AM
Thanks for you reply,
I was hoping that someone might be able to tell me the exact frequency settings etc.
Someone here must have configured FXO for BT in the UK!
Please, I don't want to mess around too much trying different solutions, I've been here before and it was a slow process...just give me the commands! ;)
Thanks,
10-17-2007 05:08 AM
Hope someone can fill in there with the exact settings. However in my experience there is no substitute for doing things yourself.
You can find the tones definitions at:
10-17-2007 05:13 AM
Thanks, I've got that page bookmarked! Its very useful.
I don't have too much time for testing unfortunately, hence the request for speedy results!
best regards,
Peter
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: