10-17-2007 07:56 AM - edited 03-18-2019 07:57 PM
When I plug in a 7941, it gets the inline power from the switch, lights all LEDs and performs the following cycle:
Breifly lights the Mute button, and then lights the Speaker button. After about 10 seconds, the Speaker light goes off, line 1 button blinks amber once, line 2 button blinks green once and the Headset button gets lit. Then line 1 button blinks green once and line 2 button blinks green once. The Headset button stays lit. After about 19/20 blinks of the green line buttons, The Headset light goes off and the cycle starts again from the breif lighting of the Mute button.
This cycle takes about 2 minutes. There is never any information displayed on the LCD screen, and therefore will not register. Is this recoverable?
10-17-2007 08:40 AM
Hi Score,
Have a look at this thread with some excellent info from NetPro Paolo :) He doesn't monitor this Forum usually so I thought I would pass this along;
Hope this helps!
Rob
10-17-2007 01:48 PM
Hi -
In addition to Rob's post, make sure the CallManager has the correct phone model selected, i.e. the behavior you are seeing will be similar if a 7960 model was chosen for the MAC by mistake. Speaking from experience ;-)
Ginger
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide