6550 Switch 1000BastT module installation

Unanswered Question
Oct 18th, 2007
User Badges:

hi,


i installed one WS-X6148-GE-TX on 13th slot of a 6513 while it was powered on. After detecting the module, the "show module" shows '48 unknown FRU type (major = 0x6003, mino".


Does the swithc require a reboot, does it have any minimum IOS version requirement ?


THe SUP engine is Catalyst 6000 supervisor 2 (Active) (WS-X6K-SUP2-2GE).


thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ankbhasi Thu, 10/18/2007 - 02:43
User Badges:
  • Cisco Employee,

Hi Friend,


You need minimum 12.1(19)E1 release to support this card. Which release are you running on your sup?


Regards,


Ankur

glen.grant Thu, 10/18/2007 - 03:22
User Badges:
  • Purple, 4500 points or more

If its running catos you need at least code version 7.6.1 to support the card.

Actions

This Discussion