Console messages on 3640 router.

Unanswered Question
Oct 18th, 2007
User Badges:

I have a 3640 router I am trying to use as an Access server. After configuring the lines, I am getting interface resets as indicated below. Does anyone know how I can stop these. The phone lines are not connected to the ports yet.


%LINK-3-UPDOWN: Interface Async70, changed state to up

%LINK-3-UPDOWN: Interface Async104, changed state to up

%LINK-3-UPDOWN: Interface Async105, changed state to up

%LINK-3-UPDOWN: Interface Async106, changed state to up

%LINK-5-CHANGED: Interface Async99, changed state to reset

%LINK-5-CHANGED: Interface Async65, changed state to reset

%LINK-5-CHANGED: Interface Async66, changed state to reset

%LINK-5-CHANGED: Interface Async67, changed state to reset

%LINK-5-CHANGED: Interface Async100, changed state to reset

%LINK-5-CHANGED: Interface Async101, changed state to reset

%LINK-5-CHANGED: Interface Async102, changed state to reset



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
aghaznavi Wed, 10/24/2007 - 06:12
User Badges:
  • Silver, 250 points or more

The reason you probably have these call disconnected is during PPP negotiation so you can monitor this by enabling thr following debugs

debug ppp authentication

debug ppp negotiation

debug isdn q931

this way we can see the disconnect and reset reasons for the call. make sure you to assign terminal monitor command to see the debugs.

Actions

This Discussion